Bosch SGE63E05UC/32 Operating Instructions Manual page 8

To achieve proper drying, always use a liquid rinse agent, even if your detergent
contains a rinse agent or drying additive.
Rinse Agent Dispenser
Open the rinse agent dispenser by lifting the tab with your thumb.
NOTE:The dishwasher indicates Iow rinse agent either by showing the symbol _TC in
the display, or illuminating the refill rinse agent LED (model dependent). If the
symbol is displayed or the LED is on, you need to refill the rinse agent dispenser.
Add liquid rinse agent to the dispenser as shown until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir
is full.
Setting amount of rinse agent
The amount of rinse agent dispensed can be set from "r:O0" to "r:06".
To change setting:
o Open the door (for hidden controls only).
o Turn unit on by pressing the ION/OFF] button.
o Hold down button "A" (see page 4) and press [START] until the display in-
dicates "H:O0".
o Release both buttons.
o Press the "A" button until the display indicates "r:OS".
o Press the "C" to select the desired setting.
• "r:O0"= dispenser is off
• "r:01" = lowest setting
• "r:02"= low setting
• "r:03"= medium setting
• "r:04"= high setting
• "r:05"= high setting
• "r:06"= highest setting
o Save the selected setting by pressing [START].
o Close the door (for hidden controls only).
Switching off rinse agent re_ll indicator
o Set the rinse agent option to "r:O0" by following the above steps.
NOTE:Do not change the amount of rinse agent unless there are streaks (select low-
er setting) or water stains (select higher setting) visible on the utensils.