Samsung PCK6115R Service Manual page 15

SAMSUNG PROJECTION TV SERVICE GUIDE
Subject: Instruction for Service Kit installation and Processing
Note: There are several versions of this chassis; some PCBs are not interchangeable with PCBs of other
versions. It is therefore imperative the chassis be changed as a unit and adjusted as described below.
1. Remove and reinstall chassis by following instructions in service manual.
2. On some versions the CRT PCB connectors may have to be modified to attach to the
replacement chassis. If the female part of the connector is black, clip the locking tabs (ears) on
both sides before inserting plug.
3. Remove back panel, containing rating label, from the defective chassis and reinstall it on the
replacement.
4. Adjust F/S voltage for 2.25V +/- .01 at J120 with VR472 on Convergence Board.
Shield
Convergence Board
5. Perform all necessary geometric and convergence adjustments.
Note:
Set Top Box Adjustment, If set top box is used (1080i mode) perform
procedure described in service bulletin
6. Repack defective chassis in the same way as it was received in shipping container along with
original packing list and copy of NARDA form.
Last update: 3/14/01
Section 4 - Micro Kit Instructions
Return to:
Samsung Parts Dept.
18600 Broadwick St.
Rancho Dominguez, CA 90220
1-800-634-8276
13
Important! Read First
PRODUCT: DTV
MODEL:
PCJ534RF, PCJ532RF, PCK5315R
PCJ614RF, PCK6115R, PCJ611RF
HCJ552W, HCJ652W
Change chassis as a unit, do not swap
individual PCB
(see note below).