Installing An Internal Wireless Print Server - Lexmark X7550 User Manual

Installing an internal wireless print server

The printer you purchased may contain an internal wireless print server that allows the printer to be used on a wireless
network. If your printer does not have an internal wireless print server already installed, you can purchase one
separately. Use the following instructions to install the internal wireless print server:
1
Turn off your printer, and then unplug the power cord from the wall outlet.
Warning: Failure to unplug the printer can cause damage to your printer and to the internal wireless print server.
Make sure the printer is turned off and the power cord is unplugged from the wall outlet before you proceed.
2
Remove the back cover plate by pushing the tab down and then pulling the cover away from the printer.
3
Unpack the internal wireless print server. Save the packaging materials.
Warning: Wireless print servers are easily damaged by static electricity. Touch something metal such as the
printer frame before you touch the wireless print server.
4
Align the edges of the internal wireless print server with the guides on the left and right, and then slide the wireless
print server into the printer until it snaps into place.
5
Make sure the antenna points up.
6
Attach the adhesive label with the MAC address to the back of the printer. You will need this later to in order to
network the printer.
Networking the printer
16