Maintenance; Recommended Maintenance; System - Toro TimeCutter SS 4235 Operator's Manual

Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Maintenance Procedure
Interval
After the first 8 hours • Change the engine oil.
Before each use or daily
Every 25 hours
Every 100 hours
• Check the safety interlock system.
• Check the engine oil level.
• Clean the air intake screen.
• Check the cutting blades.
• Inspect the grass deflector for damage
• Clean the mower housing.
• Grease all lubrication points.
• Check tire pressure.
• Check the belts for wear/cracks.
• Service the paper element. (more often in dusty, dirty conditions)
• Change the engine oil. (more often in dusty, dirty conditions)
• Check the spark plug(s).
• Replace the in-line fuel filter
• Inspect the emissions filter.
• Replace the paper element. (more often in dusty, dirty conditions)
Every 200 hours
• Change the oil filter. (more often in dusty, dirty conditions)
• Charge the battery and disconnect battery cables.
Before storage • Perform all maintenance procedures listed above before storage.
• Paint any chipped surfaces.
Important:
Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
27