Cub Cadet GT1554 Operator's Manual page 13

Systems IndicatorMonitor/Hour Meter Brake
©
BATT.
42.01
/// HOURS 1/10 \\\
PTO / BLADE PARKING
© ©
LCD
When the ignition key is rotated out of the STOP position but not
into the STARTposition, the systems indicator monitor displays
the battery's output, in volts, on its LCDfor approximately five
seconds, after which it displays an hour glass and the hours
of tractor operation. Once the tractor is started, the monitor
continually displays an hour glass and the hours of tractor
operation on its LCD.
NOTE; Hours of tractor operation are recorded any time the
ignition key is rotated out of the STOPposition, regardless of
whether the engine is started.
The Indicator Monitor will also remind the operator of
maintenance intervals for changing the engine oil. The LCD will
alternately flash the recorded hours, "CHG" and "OIL" for five
minutes, after every 50 hours of recorded operation elapse. The
maintenance interval lasts for two hours (from 50-52,100-102,
150-152, etc.). The LCDwill also flash as described above for five
minutes every time the tractor's engine has been started during
this maintenance interval. Before the interval expires, change
the engine oil as instructed in the Maintenance section of this
Operator's Manual.
If the Brake light illuminates when attempting to start the
tractor's engine, depress the brake pedal.
PTO(Blade Engage)
If the PTO light illuminates when attempting to start the tractor's
engine, move PTO lever into the disengaged (OFF) position.
0il
It is normal for the Oil light to illuminate while the engine is
cranking during start-up, but if it illuminate's during operation,
while the engine is running, stop the tractor immediately and
check the engine oil level as instructed in this Owner's Manual.
Battery
It is normal for the Battery light to illuminate while the engine is
cranking during start-up, but if it illuminate's during operation,
while the engine is running, the battery is in need of a charge
or the engine's charging system is not generating sufficient
amperage. Charge the battery as instructed in the Service
section of this manual or have the charging system checked by
your Cub Cadet dealer.
PTO / Blade EngageKnob
Activating the PTO engages power to
the cutting deck or other (separately
available) attachments. Pull outward
on the PTO/Blade Engage knob to
activate it, Push the PTO/Blade Engage
knob inward to disengage the power
to the cutting deck or other (separately
available) attachments.
NOTE:The PTO/Blade Engage knob
must be in the disengaged (OFF)
position when starting the engine.
PTO
OFF ON
SECTION 4
-- CONTROLS AND FEATURES
13