Table of Contents
Advertisement
Cinema
Wide3
(for letter
box
programs
with
subtitles)
To fill the width of the screen,
it is extended
horizontally.
However;
it is only slightly extended
at the
top and the bottom.
The top and bottom edges of the picture may be hidden.
Full
(for
16:9
source
programs)
Full will display the picture at the maximum
size.
Native
(for
PC mode
only)
Detects the resolution of the signal of the image and it
will be shown on the screen with same amount of pixels.
NOTE:
• Some High Definition
and/or Digital broadcasts
may
not allow you to change the picture size.
• In HDMI or COMPONENT
mode with a scanning
rate of 720p or 1080i, only the Cinema Wide2
and
Full picture size feature
is available.
• In PC Mode, only the Natural,
Full and Native
picture size features
are available.
In PC Mode
(WXGA),
only the Full and Native picture size
features
are available.
Film mode
A smoother
motion
may be obtained
by setting
the Film Mode to "On" when you view a DVD.
=4
|
Press SETUP/TV
MENU
in the TV mode.The
TV
menu screen will appear.
2
Press • or • to select"Picture",
then press
• or
ENTER.
3
Press • or • to select"Film
Mode".
Press < or • to select "On" or "Off".
4
Press EXIT/CANCEL
to return to the normal screen.
Picture control
adjustment in the PC mode
You can adjust
to optimize
the performance
of
the TV in the PC mode.
,I
Press SETUP/TV
MENU. The TV menu screen
will appear.
3
Press • or • to select"Picture",
then press
• or
ENTER.
4
Press • or • to select"PC
Setting",
then press •
or ENTER.
The PC Setting
menu will appear.
Press•or•
to adjust.
Press<or•
Hor
Position:
Vet
Position:
Clock:
7
8
to select the desired
item you want
to adjust the setting.
To adjust the horizontal
position
of
the image on the PC mode.
To adjust the vertical
position
of the
image on the PC mode.
To minimize
any vertical bars
or stripes visible
on the screen
background.
Phase:
This must be adjusted
after the
frequency
of the PC mode has
been set to 60Hz to optimize
picture quality
(page 39).
Auto Adjust:To
adjust the all PC settings
automatically
After adjusting, press ENTER to return to the PC
Setting menu. Then continue to adjust the other items.
Press EXIT/CANCEL
to return to the normal screen.
NOTE:
• Auto Adjust
feature is available
only for 16:9 or 4:3
format.
• If no buttons are pressed
for more than approx. 60
seconds,
the Menu-screen
will return to normal
Monitor-screen
automatically.
• The PC settings are not effective for other input modes.
DNR
DNR (Digital
Noise
Reduction)
can reduce
the
roughness
of the picture.
1
Press SETUP/TV
MENU
in the TV mode.The
TV
menu screen will appear.
2
Press • or • to select"Picture",
then press
• or
ENTER.
Press • or • to select"DNR".
Press • or • to
select "On" or "Off".
1
Press INPUT SELECT,
then press •/•
or
4
Press EXIT/CANCEL
to return to the normal screen.
Number
button
(6) to select the PC mode.
23
Advertisement
Table of Contents
