Epson EMP-52 User Manual page 65

When Having Some Trouble
Internal
Red
problem
(1-second
intervals)
High-speed
Orange
cooling in
progress
Tip :
• If the projector is not operating properly even though the indicators are all showing
normal, refer to "When the Indicators Provide No Help" on the following page.
• If an indicator is showing a status which does not appear in the previous tables,
contact your dealer or the nearest address provided at "International Warranty
Conditions" in Safety Instructions/World-Wide Warranty Terms.
If the lamp is broken replace by a new lamp,
or contact your local dealer for further advise.
If replacing the lamp yourself, be careful to
avoid pieces of broken glass.
(Projection cannot be carried out until the
lamp is replaced.)
Check that the lamp and the lamp cover are
securely installed. If the lamp or lamp cover is
not securely installed, the lamp will not switch
on.
Stop using the projector, disconnect the power
cable from the electrical outlet, and contact
your dealer or the nearest address provided at
"International Warranty Conditions" in Safety
Instructions/World-Wide Warranty Terms.
(This is not an abnormality, but if the
temperature rises too high again, projection
will stop automatically.)
• Set the projector up in a place which is well-
ventilated, and so that the air filter and
exhaust vents are clear.
• Clean the air filter.
63
p.76
p.76
p.16
p.73