Tools Required For Assembly; Check Battery - Craftsman 917.28001 Operator's Manual

Steering Wheel
Insert Steering
Boot
Steering Wheel
%
(1) Rear Bumper
%
(1) Front Bumper
Steering Shaft
Extension
(1) 5/16-18 x 4
Hex Bolt (1) Lockwasher Steering
Shaft Cover
Steering Wheel (1) Large Flat
Adapter Washer
Seat
@
(1) Cup Washer
(1) Knob
(1) Shroud
Slope Sheet
(4) Screw
#10 x 0.200
Inq
(2) Key
Your new riding mower has been assembled at the factory with the exception of those parts
left unassembled for shipping purposes. To ensure safe and proper operation of your riding
mower all parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set wilt make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 1/2" wrench (1) Utility knife
(1) Tire pressure gauge
NOTE: Only cut carton with a short blade
utility knife, a long blade or saw can puncture
tires on unit.
HOW TO SET UP YOUR RIDING
MOWER
CHECK BATTERY
When right or left hand is mentioned in
this manual, it means when you are in the
operating position (seated behind the steer-
ing wheel).
TO REMOVE RIDING MOWER FROM
Ensure battery is securely fastened, and that
all wires are securely connected.
• Battery is located under the seat.
• Battery has been fully charged from the
factory, before installation.
CARTON
UNPACK CARTON
1. Remove all accessible loose parts and
parts boxes from carton.
2. Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
3. Remove packing materials from riding
mower,
4. Check for any additional loose parts or
cartons and remove.
Seat
7