GE Profile DPSB620 Owner's Manual page 22

Before you call for service...
LAUNDRY PRACTICES Possible Causes What To Do
Static occurs No fabric softener was used * T_' a riO)tic soitene_:
• Bounce '_Fabric Conditioner Dryer Sheets have been
approved fi)r use in all GE DITeI_ when used ill
accordance with tile i//ainlt_lcttli'ei"s instructions.
Overdxying
• T_ a e_l_Iic
solienei:
• A(!just setting to LESS DRY (>r DAMP.
Synthetics, permanent press • Try a tabric softener.
and blends can cause static
Collars and waistbands The dryness monitor senses • Choose SPEED DRYor TIMED DRYt(, diy dmnp collai_
still wet at end of cycle that the body of the clothes
_lIld
waistbands.
In tile
J[iltllI'e,
when
drying a load with
is dry collai_ and waistbands, choose MORE DRY.
Clothes take too long hnproper sorting • Separate heavy iten/s ti'om lightweight iten/s (generally,
to dry a well-sorted washer load is a well-sorted dryer load).
Large loads of heavy fabrics • im'ge heavv tabrics contain more moisture and take
(like beach towels) hmger to diy. Separate lmge, heavv rift)tics into smaller
loads to speed (hying fiule.
Controls improperly set • Match control settings to tile load you are drvin ,
Lint filter is full • Clean lint filter befi)re eveP,' load.
hnproper or obstructed ducth_g • Check installation instructions fi)r proper
ducting/venfing.
• Make sure ducting is clean, fl'ee ot kinks and
unobstructed.
• Check to see if outside wall dmnper operates easily.
• Check tile Installation hlstructions to make sure tile
dryer venting is correct.
Blown fuses or tripped circuit • Replace fllses or reset circuit breakei_. Since lnost
breaker drveI_ use 2 fllses/breakei_, make sure both are
operating.
OverloadJng/combhfing loads
• Do not put inore
than one washer load ill tile dryer at
a [Jill e.
Underloadhag • If xou are (hying only one or two items, add a tew items
to ensure proper tulnbling.
22