Advertisement
Available languages
Available languages
TO INSTALL STEERING WHEEL
1. Slide extension shaft onto steering shaft.
2. Slide steering shaft protective foam cover
over steering shaft.
3. Place steering boot over steering shaft
and push down to secure.
4. Position fr0nt wheels ofthe riding mower
so they are pointing straight forward.
5. Remove steering wheel adapter from
steering wheel and slide adapter onto
steering shaft,
7. Press steering wheel into position on
shaft, install large washer, lock washer,
bolt and tighten securely.
8. Snap steering wheel insert into center of
steering wheel securely.
7. Slide seat until a comfortable position is
reached whichallows you to pressclutch/
brake pedal all the way down.
8. Get off seat without moving its adjusted
position.
9. Raise seat and tighten adjustment knob
securely.
Seat Pan
Pads
Steering Boot_.....
Extension
Shaft _
FoamCover
f
g Shaft
TO INSTALL SEAT
Adjust seat before tightening adjustment
knob.
t.
Remove adjustment
knob and cup
washer securing seat to cardboard pack-
ing and set aside.
2, Remove seat from the cardboard pack-
ing and set seat aside, Remove the
cardboard packing and discard.
3. Place seat on seat pan so all three (3)
bottom pads are positioned over large
slotted holes in pan.
4. Push down on seat to engage pads in
slots and pull seat towards rear of the
riding mower,
5. Pivot seat andpanforward and assemble
adjustment knob and cup washer loosely.
Do not tighten.
6. Lower seat into operating position and
sit in seat,
Cup Washer
Adjustment _'_\
NOTE:
You may now rolt your riding
mower off the skid. Follow the appropriate
instruction below to remove the riding mower
from the skid.
WARNING: Before starting, read, un-
derstand and fo_low all instructionsin the
Operation section of this manual. Be sure
riding mower is in a well-ventilated area.
Be sure the area in front of riding mower is
clear of other people and objects.
TO ROLL RIDING MOWER OFF
SKID (See Operation
section for
location and function
of controls)
1. Raise deck liftleverto itshighest position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Shift unit to neutral.
4. Roll riding mower forward off skid.
•
Advertisement
