Emerson ControlWave EFM 3808 Instruction Manual page 64

ControlWave Express Instruction Manual (CI-ControlWave Express)
5-4
Figure 5-2. HyperTerminal
In the Send File dialog box (see Figure 5-3), select 1KXmodem
8.
for the protocol, enter the filename of the appropriate .bin file in
the format "E1Sxxxxx.bin" or "E3Sxxxxxx.bin" (where E1S
refers to 14 MHz CPUs, and E3S refers to 33 MHz CPUs and
xxxxx varies from release to release) and click Send to start the
flash upgrade (see Figure 5-4). When you see the
HyperTerminal Mode Menu again, it means the download has
completed.
Exit HyperTerminal and power down the ControlWave Express.
9.
If desired, you can disconnect the null modem cable between the
ControlWave Express and the PC.
Set switch SW1-3 to the OFF position (OFF = Recovery Mode
10.
Disabled).
Restore power to the ControlWave Express.
11.
Figure 5-3. Send File dialog box
Service & Troubleshooting
(Ready to Download)
Revised Mar-2011