Intel Desktop Board D915GLVG Product Guide
Main Memory
NOTE
To be fully compliant with all applicable Intel
be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your
memory modules do not support SPD, you will see a notification to this effect on the screen at
power up. The BIOS will attempt to configure the memory controller for normal operation.
The desktop board supports dual or single channel memory configurations. Desktop Board
D915GLVG supports dual or single channel memory configurations defined in Table 3.
Table 3.
Desktop Board D915GLVG Memory Configurations
Memory
Processor
Speed
DDR 400
Intel
Intel Pentium 4 processor
Intel
DDR 333
Pentium 4 processor
Pentium 4 processor
Intel Celeron D processor
Desktop board D915GLVG supports:
•
Four 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory Module (DIMMs)
connectors with gold-plated contacts
•
Unbuffered, non-registered single or double-sided DIMMs
•
Serial Presence Detect (SPD) memory only
•
Non-ECC RAM
•
2.5 V memory
•
Memory configurations listed below:
⎯ Up to 1.0 GB utilizing 128 Mb technology
⎯ Up to 2.0 GB utilizing 256 Mb technology
⎯ Up to 4.0 GB utilizing 512 Mb or 1 GB technology
NOTE
System resources (such as PCI and PCI Express) require physical memory address locations that
reduce available memory addresses above 3 GB. This may result in less than 4 GB of memory
being available to the operating system and applications.
Related Links:
Go to the following links or pages for more information about:
•
The latest list of tested memory,
•
SDRAM specifications,
•
Installing memory, page 32 in Chapter 2
14
®
®
Pentium
4 processor
®
®
Celeron
D processor
http://support.intel.com/support/motherboards/desktop/
http://www.intel.com/technology/memory/
®
SDRAM memory specifications, the board should
FSB frequency
(MHz)
800
533
800
533
Memory Speed Outcome
(MHz)
400
400
333
333