ASROCK 939S56-M Manual page 10

5. When the RAID0 array's configuration is finished, click the Create
button. Then a "Create Stripe RaidSet" dialog will pop up.
<Option Description>
Source:
Target:
Create Only:
Source is not
a boot device:
Source is a boot
device:
OK:
<Disk Copy Remaining Sector>:
Show the remaining splitting data.
6. Next, you may click Cancel button to leave, or click OK button to
continue after the operation being selected. Different warning mes-
sages will pop up according to the option you select. The warning
messages are similar to JBOD array creation but the operation is
"Split data into Raid0".
The first selected disk.
The second selected disk.
Select this option will destroy all data on all
the selected disks and create a clean stripe
array without any data on it.
Select this option will split data from source
disk into all the selected disks. In this option,
the source cannot be bootable.
Select this option will split data from source
disk into all the selected disks. In this option,
the source can be bootable.
Start the operation.