Electrolux EWP 106100 W User Manual page 17

Indicator pilot lights
7.1
7.2
7.3
AT THE END OF THE PROGRAMME
The appliance stops automatically. The pilot
light of the button 6 and the pilot light cor-
responding to the just finished washing
phase go off. The light 7.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected and
the door remains locked to indicate that the
water must be emptied out before opening
the door.
Follow the below instructions to empty out
the water:
• Turn the programme selector dial to
• Select the draining or spinning pro-
gramme.
• Reduce the spin speed if needed, by
pressing the relevant button.
• Press the button 6.
At the end of the programme, the door can
be now opened. Turn the programme se-
lector dial to to switch the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Warning! If there are children or pets
in the house, activate the child safe-
• After the programme has started the door is locked. If,
for any reason, you need to open the door, set firstly
the appliance to PAUSE by pressing the button 6. Af-
ter a few minutes it will be possible to open the door.
If the door remains locked, this means that the appli-
ance is already heating or that the water level is too
high. In any case, do not try to force the door!
If you cannot open the door but you need to open it
you have to switch the appliance off by turning the se-
lector dial to . After a few minutes the door can be
opened (pay attention to the water level and tem-
perature!). After closing the door, it is necessary to
select the programme and options again and to press
the button 6.
• When you start the programme by pressing the button
6, the washing phase pilot light (7.1) illuminates. This
means that the appliance is operating.
• The additional rinses pilot light (7.2) illuminates when
the appliance performs an extra rinse.
• When the programme has finished the end cycle pilot
light (7.3) comes on.
.
DOOR SEAL
At the end of every cycle, check from the
door seal and remove objects that could be
trapped in the fold.
ty device in the inner side of the door
frame (for more details read " Child
safety" in the chapter "Safety Informa-
tion").
Stand by: during programme setting
up and once the programme has finish-
ed, if the programme selector dial and
any button are not touched, after a few
minutes the energy saving system is
enabled. The pilot lights go off. The
green pilot light of the button 6 flashes
with a low frequency. By pressing any
button the appliance will come out of
the energy saving status.
electrolux 17