Electrolux EWP 106100 W User Manual page 16

16 electrolux
3 Extra Rinse
+
4
5
Delay Start
Important! The selected delay can be changed only after selecting the washing pro-
gramme again. The door will be locked throughout the delay time. If you need to open
the door, you must set the appliance to PAUSE (by pressing the button 6) and then wait
a few minutes. After you have closed the door, press the button 6 again.
6 Start/Pause
This appliance is designed for saving water. However, for
people with very delicate skin (allergic to detergents) it
may be necessary to rinse the laundry using an extra
quantity of water.
Press simultaneously the buttons 3 and 4 for some sec-
onds: the pilot light 7.2 comes on. This function stays
permanently on. To remove it press the same buttons
again until the pilot light 7.2 goes off.
The start of the programme can be delayed by 3, 6 or 9
hours by means of this button. The relevant light illumi-
nates.
You must select this option after you have set the pro-
gramme and before you start the programme.
Select a delayed start:
• select the programme and the required options;
• select the delay start by pressing the button 5;
• press the button 6:
– the appliance starts its hourly countdown.
– The programme will start after the selected delay
has expired.
Cancelling the delayed start after having started
the programme:
• set the appliance to PAUSE by pressing the button 6;
• press the button 5 once, the light relevant to the selec-
ted delay goes off;
• press the button 6 again to start the programme.
The DELAY START cannot be selected with the drain
programme.
Start the programme by pressing the button 6
• To start the selected programme, press the button 6,
the corresponding green pilot light stops flashing. The
pilot light 7.1 illuminates to indicate that the appliance
starts operating and the door is locked. If you have
chosen a delayed start, the appliance will begin the
countdown.
• To interrupt a programme which is running, press the
button 6: the corresponding green pilot light starts
flashing. It is possible to change some options of a
running programme before the programme carries
them out.
• To restart the programme from the point at which it
was interrupted, press the button 6.