Table of Contents
Advertisement
Operating
Correcting the keystone distortions
1.
Press KEYSTONE button on the remote
control. A dialog will appear on the screen
to aid you in correcting the distortion.
2.
Use the ▲/▼ cursor buttons to select AUTO or MANUAL
operation, and press the ► button to perform the following.
(1) AUTO executes automatic vertical keystone correction.
(2) MANUAL displays a dialog for keystone correction.
Use the ◄/► buttons for adjustment.
To close the dialog and complete this operation, press
KEYSTONE button again. Even if you do not do anything, the
dialog will automatically disappear after a few seconds.
● The menu or dialog will automatically disappear after several seconds of
inactivity. Pressing the KEYSTONE button again fi nishes the operation and
closes the menu or dialog.
● The adjustable range of this function will vary among inputs. For some input,
this function may not work well.
● When REAR / CEILING or FRONT / CEILING is selected for the
INSTALLATION item in the SETUP menu, the automatic vertical keystone
correction function may not work correctly if the projector screen is slanted or
tilted downwards.
● When the zoom adjustment is set to the TELE (telephoto focus), this function
may be excessive. This function should be used when the zoom adjustment
is set to the full WIDE (wide-angle focus) whenever possible.
● When the projector is placed on the level (about ±4°), the automatic keystone
distortion correction may not work.
● When the projector is inclined to near ±30 degree or over, this function may
not work well.
● This function will be unavailable when the Transition Detector is on (77).
26
KEYSTONE button
VIDEO
COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT
AUTO
SEARCH
BLANK
MAGNIFY
FREEZE
PAGE
VOLUME
UP
ON
＋
DOWN
OFF
ー
MY BUTTON
KEYSTONE
MUTE
2
1
MENU
POSITION
ENTER
ESC
RESET
Advertisement
Table of Contents
