Adjusting The Position; Correcting The Keystone Distortions - Dukane 8230W User Manual

Adjusting the position

1.
Press the POSITION button on the remote control while no menu
is on screen, to display the D-SHIFT (44) dialog on screen.
2.
Use the ▲, ▼, ◄ and ► buttons to adjust the picture position.
Press the POSITION button again to finish this operation.
● This is a function to shift the position of the shrunken picture by the D-ZOOM (44)
function.
● When an OSD (On Screen Display) menu is displayed, this operation moves the
position of the OSD menu, but not the position of the picture (31).
● The D-SHIFT adjustment values are not valid when the D-ZOOM is set to 256 (full
screen). (8232)
● The D-SHIFT adjustment values are not valid when the D-ZOOM is set to 320 (full
screen). (8230W)

Correcting the keystone distortions

1.
Press the KEYSTONE button on the remote control.
A dialog will appear on the screen to aid you in correcting the
distortion.
2.
Use the ◄/► cursor buttons for adjustment.
To close the dialog and complete this operation, press the
KEYSTONE button again. Even if you do not do anything, the
dialog will automatically disappear after about ten seconds.
● The adjustable range of this function varies for each input signal. For some input,
this function may not work well.
● When the projector is inclined to near ±5 degrees or over, this function may not
work well.
● The OSD menu might be displayed outside of the image display area depending
on the adjustment value of the ASPECT, D-ZOOM and
the values of ASPECT, D-ZOOM and KEYSTONE may fix the symptom.
INPUT IWB
ASPECT AUTO
Operating
PAGE MAGNIFY
UP ON
DOWN OFF
KEYSTONE TEMPLATE
ESC
POSITION
POSITION button
KEYSTONE button
INPUT IWB CALIBRATION
ASPECT AUTO ACCENTUALIZER HDCR
D-ZOOM
-
PAGE MAGNIFY MYBUTTON
UP ON
1
DOWN OFF 2
KEYSTONE TEMPLATE FREEZE
ESC
ENTER
POSITION
KEYSTONE. Changing
CALIBRATION
ACCENTUALIZER HDCR
D-ZOOM
- +
MYBUTTON VOLUME
1 ＋
2 ー
FREEZE AV MUTE
MENU
ENTER
RESET
+
VOLUME
＋
ー
AV MUTE
MENU
RESET
27