Table of Contents
Advertisement
Operating
Correcting the keystone distortions
1.
Press KEYSTONE button on the remote
control. A dialog will appear on the screen to
aid you in correcting the distortion.
2.
Use the ▲/▼ cursor buttons to select AUTO or MANUAL
operation, and press the ► button to perform the following.
(1) AUTO executes automatic vertical keystone correction.
(2) MANUAL displays a dialog for keystone correction.
Use the ◄/► buttons for adjustment.
To close the dialog and complete this operation, press
KEYSTONE button again. Even if you do not do anything, the
dialog will automatically disappear after a few seconds.
● The adjustable range of this function will vary among inputs. For some input, this
function may not work well.
● When V:INVERT or H&V:INVERT is selected to the MIRROR item in the SETUP
menu, if the projector screen is inclined or angled downward, automatic vertical
keystone correction may not work correctly.
● When the zoom adjustment is set to the TELE (telephoto focus), this function may
be excessive. This function should be used when the zoom adjustment is set to
the full WIDE (wide-angle focus) whenever possible.
● When the projector is placed on the level (about ±4°), the automatic keystone
distortion correction may not work.
● When the projector is inclined to near ±30 degree or over, this function may not
work well.
● This function will be unavailable when Transition Detector is on (54).
20
KEYSTONE button
MY SOURCE/
VIDEO
COMPUTER
DOC.CAMERA
AUTO
ASPECT
SEARCH
BLANK
MAGNIFY
FREEZE
PAGE
VOLUME
UP
ON
DOWN
OFF
KEYSTONE
MY BUTTON
MUTE
1
2
POSITION
MENU
ENTER
RESET
ESC
Advertisement
Table of Contents
