Table of Contents
Advertisement
Powering the projector On / Off
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
3. Turn on the lamp by pressing " " button either on the top of
When Power mode
(Standby) is set
to Eco (<1W), the
VGA output, Audio
pass-through
and RJ45 will be
deactivated when
4. Turn on and connect the source that you want to display
the projector is in
standby.
Turn on the
projector first and
then select the
signal sources.
Powering On the Projector
connected, the POWER/STANDBY LED will turn Amber.
the projector or on the remote. The POWER/STANDBY LED
will now turn Green.
The startup screen will display in approximately 10 seconds.
The first time you use the projector, you will be asked to
select the preferred language and power saving mode.
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, push
menu button and go to "OPTIONS".
Make sure that the "Source Lock" has been set to "Off".
If you connect multiple sources at the same time, press the
"SOURCE" button on the control panel or direct source keys
on the remote control to switch between inputs.
2
1
Lens Cap
Installation
Power
13
English
Advertisement
Table of Contents
