Honeywell Dolphin Power Tools User Manual page 83

Comm Section
The serial port settings in the Comm section determine the interaction between ScanWedge and the serial
port.
Comm Section Description
Key
Powerout Enables and disables power out of the
serial port for ScanWedge specifically.
General power out settings are
established in the registry.
The serial port powers out 5V at
500mA.
This parameter is supported for all
software configurations of the Dolphin
7900 and for the following software
configurations of the Dolphin 9500:
• Kernel 7.01, SP8 or later
• Kernel 7.03, SP1 or later (Kernel 7.03
EnablePrefixData Enables or disables all prefix data
received via COM port after a
successful scan.
All prefix data is defined in the
Section
EnableSuffixData Enables or disables all suffix data
received via COM port after a
successful scan.
All suffix data is defined in the
Section
alone is not supported.)
(see page 5-3).
(see page 5-3).
Default Available Values
Value
0 0=Disabled; do not power out when
1=Enabled; power out when scanning
2=No change for ScanWedge. This
0 0=Disabled
1=Enabled
Settings
0 0=Disabled
1=Enabled
Settings
scanning with ScanWedge
with ScanWedge.
means that ScanWedge is not altering
the default power out setting in the
registry. The terminal defaults to the
power-out setting in the registry.
5 - 7