Cleaning The Print Head - Epson WorkForce WF-3530 Quick Manual

Cleaning the Print Head

If print quality has declined and the nozzle check indicates clogged nozzles, you can clean
the print head. Print head cleaning uses ink, so clean it only if necessary.
Note: You cannot clean the print head if an ink cartridge is expended, and may not be
able to clean it when a cartridge is low. You must replace the cartridge first (see
page 26).
1. Press
2. Select
Maintenance
3. When you see the first screen, press
Tip: Use the nozzle check pattern to determine which colors need cleaning. You
can save ink by cleaning only selected colors.
Cleaning takes a few minutes. When it's finished, you see a message on the LCD
screen.
Caution: Never turn off the product during head cleaning or you may damage it.
4. Select
Print Nozzle Check Pattern
nozzle check and confirm that the print head is clean.
Note: If you don't see any improvement after cleaning the print head four times, leave
the product on and wait at least six hours to let any dried ink soften. Then try cleaning
the print head again. If quality does not improve, one of the ink cartridges may need to
be replaced. If that doesn't help, contact Epson as described on page 35.
If you do not use your product often, it is a good idea to print a few pages at least once
a month to maintain good print quality.
24
Cleaning the Print Head
if necessary, then press l or r, select
, then
Head Cleaning.
, and press
Setup
, then choose the ink set you want to clean.
OK
. Then press one of the x buttons to print the
.
OK