Emerson Research iP100 Owner's Manual page 14

OPERATING INSTRUCTIONS(CONTINUED)
SETTING THE ALARM
1 4 1 1
ALARM
AM
.
Press and hold the ALARM
SET button to enter the alarm
Time setting mode. The front
panel display will change from
current time to alarm time.
Note: The POWER switch must
be set to the 'Off' position to
adjust the Alarm time.
1 4
AM
Press the ALARM ON/OFF
button to activate the alarm.
The ALARM indicator on the
front panel will turn 'On'.
Set the FUNCTION selector
to the desired alarm mode,
Radio or Buzzer.
1 2
ALARM
AM
.
While continuing to hold the
ALARM SET button press
the HOUR button repeatedly
until the display shows the
desired wake-up hour. Be
sure to observe the AM/PM
indicator to confirm that you are
setting the alarm time correctly.
At the selected time the unit will turn
on to the Radio or Buzzer.
The Radio will play for one hour and
then shut off automatically.
The Buzzer alarm will continue for 3
minutes and then stop.
IMPORTANT!
Even though the buzzer sound
stops after 3 minutes the power
remains 'on' for an additional 57
minutes until the alarm time is over.
During this period you cannot turn
the power 'off' by just pressing the
POWER ON/OFF button.
To turn the power 'off' immediately
you must first press the
ALARM ON/OFF button to shut off
the alarm, then press the
POWER ON/OFF to shut the power
'off' completely.
13
1 3
AM
.
While continuing to hold the
ALARM SET button press
the MINUTE button repeatedly
to se the desired wake-up
minute. When the desired
wake-up time appears on the
display release all the buttons.
1 5
To stop the alarm sooner,
press the ALARM ON/OFF
button once. The alarm stops
immediately but the alarm
indicator remains 'On' and the
alarm will turn on again on the
following day. To deactivate
the alarm so that it does not
repeat on the following day
press the ALARM ON/OFF
button once more. The alarm
indicator goes 'Off'.