Replacing An Optical Drive - Lenovo E100 Hardware Maintenance Manual

Replacing an optical drive

1. Remove the left-side and right-side covers. See "Removing the covers" on page
2. Disconnect the power cable and signal cable from the optical drive.
3. Remove the front bezel by removing the two screws and releasing the six
4. Remove the metal shield from the drive bay by inserting a flat-blade
86.
plastic tabs inside the chassis and then completely remove the bezel. Feed the
power LED cable through the front chassis opening as the bezel is removed.
Note: Be careful so that you do not break the power LED cable, because the
cable is attached to the bezel assembly.
screwdriver into one of the slots and gently prying it loose.
Chapter 8. Replacing FRUs (Type 9626)
99