Replacing A Hard Disk Drive - Lenovo E100 Hardware Maintenance Manual

Replacing a hard disk drive

1. Remove the covers. See "Removing the covers" on page 86.
2. Disconnect the signal and power cables from the rear of the hard disk drive.
3. Remove the two screws at the rear of the right side cover and slide the cover to
4. Remove the two screws that secure the drive on each side.
Important
When you install a new hard disk drive, you also need a set of Product
Recovery discs. The set of Product Recovery discs will enable the contents of the
hard disk to be restored to the same state as when the computer was
originally shipped from the factory. For more information on recovering
factory-installed software, refer to "Recovering software" in the User Guide.
the rear to remove.
Chapter 8. Replacing FRUs (Type 9626)
97