Attaching The Presser Foot Shank - Singer 5532 Instruction Manual

Attaching the Presser Foot Shank

Raise the presser bar (a) with the presser foot lifter. Loosen
or remove the presser shank screw. Line up the opening in
the shank with the opening on the presser bar and then
tighten the screw. (1)
Attaching the presser foot
Lower the presser foot shank (b) using the presser foot lifter,
until the cut-out (c) is directly above the pin (d). (2) The
presser foot (f) will engage automatically.
Removing the presser foot
Raise the presser foot using the presser foot lifter. (3)
Raise the lever (e) and the foot disengages.
Attaching the e dge/ quilting
Attach the e dge/ quilting
Adjust as needed for hems, pleats, quilting, etc. (4)
Attention:
Turn power switch to off ("O") when carrying out any of
the above operations!
guide
guide (g) in the slot as illustrated.
a
b
1
e
3
a
e
c
b
d
f
2
g
4