Advertisement
Quick Links
.
INSTRUCTION SHEETNO.
INSTRUCTIONS
FOR ASSEMBLY
AND INSTALLATION
FIXTURES
COVERED
BY THIS INSTRUCTION
SHEET
4170&
4171
IS:4170
osa9
READ AND UNDERSTAND
THESE
INSTRUCTIONS
BEFORE
INSTALLING
FIXTURE.
This fixture
is intended
for installation
in accordance
with the National
Electrical
Code and local regulations.
To assure full compliance
with local codes and regulations,
check with your local electrical
inspector
before
installation.
To prsvent electrical
shock, turn off electricity
at fuse box before proceeding.
Retain these instructions
for maintenance
reference.
1. Thread MOUNTING
STUDS into CROSSBAR.
Attach
CROSSBAR
to OUTLET BOX with
OUTLET BOX SCREWS.
2. Make connections
Black fixture
lead or fixture
lead without
tracer mark to black supply
lead;
white fixture
lead or fixture
lead with tracer
mark to white supply
lead. Uninsulated
wire is
a GROUND WIRE and must be attached
to
ground terminal
or GROUND WIRE in OUTLET
BOX. Use WIRE NUTS (local hardware
item).
Place connections
in OUTLET BOX.
3. Place CANOPY SUB-ASSEMBLY
over
MOUNTING
STUDS and tighten
with CAP
SCREWS.
4. Install recommended
lamps.
5. Attach
GLASS SHADE by looping
WIRE
HARPS carefully
over MOUNTING
HOOKS
(Fig, 2).
STUD (Fig. 2).
FIG. 2
/0?
(-r+rn~""''m'"x
"0"""
"RE~-
-
I
WIRE HARP (2)
\
FIG. 1
GLASS SHADE ~
\
LEVELING KNOB
LEVELING STUD
!
MOUNTING HOOK
//
' \wlREHARp
Advertisement
