Manual Network Connection Setting - Wireless Lan; Preparation For Wireless Lan Connection - Hitachi CPX2 User's Manual And Operating Manual

2. Equipment connection and network setting
2.4 Manual network connection setting – Wireless LAN
By installing SD-Link11g card, PC and projector are able to communicate in both
Ad-Hoc and Infrastructure modes.
How to set up wireless LAN connection manually.

2.4.1 Preparation for wireless LAN connection

Fig. 2.4.1.a Without access point communication (Ad-Hoc)
Fig. 2.4.1.b With access point communication (Infrastructure)
* Ad-Hoc is one of the wireless LAN communication methods without having
access point to communicate.
* Infrastructure is one of the wireless LAN communication methods with having
access point to communicate. If certain quantities of equipments are used, this
mode is efficient.
If communicating with existing network, contact your network administrator.
First, insert the SD wireless network card into SD card slot (Using an SD card of
the User's Manual - Operating Guide).
Then, make PC ready for wireless communication.
In case IEEE802.11b/g wireless LAN device is built-in the PC, make it valid and
make other network connections invalid. If wireless LAN device is not built-in the
PC, connect IEEE802.11b/g wireless LAN device and install device driver. (Refer
to the user guide for PC and wireless LAN device for detail.)
16