Installation Of Battery - Hitachi AX-M136i Instruction Manual

Installation of Battery

Caution: Be careful when you press the slot of the battery compartment with your fingernails
only as this might break them.
Handling the Remote Control
• Improper use could cause corrosion or battery leakage and may result in physical injury and/
or property damage including fire.
•
Never mix used and new batteries in the device.
•
Replace all the batteries in a device at the same time.
•
Remove the batteries if the remote control is not going to be used for an extended period of
time.
•
To avoid possible failure, read the following instructions and handle the remote control
property.
•
Do not drop or cause impact to the remote control.
•
Do not spill water or any liquid on the remote control.
•
Do not place the remote control on a wet object.
•
Do not place the remote control under the direct sunlight or near sources of excessive heat.
•
Do not use caustic cleaners ( porcelain, stainless steel, toilet, or oven cleaner etc. ) on the
remote, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.
Effective range
1. Press the slot on the battery compartment.
2. Pull out the battery compartment.
3. Replace a new battery (size 2025) correctly and fully insert
the battery compartment back to the original position.
* Batteries contain chemical substances, so they should be
disposed of properly.
- 7 -
Do not:
Make sure that there is no obstacle
between the infrared receiver of the
unit and remote control.
Do not expose the infrared receiver to
direct sunlight or other strong light,
such as inverter fluorescent light.
Note:
If you install the unit on rack, etc., the
remote controllable range may decrease
depending on the thickness or colour of
glass door of rack.