HK250.O/M.QXD
9/26/02
STORING NAMES AND TELEPHONE NUMBERS
The memory can store up to 20 name/telephone numbers.
1
Press the PROG button while in the
Standby mode.
NOTES:
•
If a 17th digit is entered, the Store mode will be terminated with an error tone.
•
If you misdial, press the ERASE button to clear the last digit.
•
If desired, pause can be inserted between digits by using the PAUSE button.
When a pause is entered, "P" will be displayed.
3
1
4
2
4
2
Press the MEMO button . Enter two
digits (01-20) using the Key buttons
to assign the desired memory location
to store the data. "0" must be added for
memory locations 1 - 9.
NOTES:
•
If the data is stored in a location where data has already been stored, the old
data will be overwritten.
3:49 PM
Page 21
BASIC OPERATION (CONTINUED)
See the Character Map Chart on the top of the next
page and using the Key buttons (0-9,*,#) , enter the
name. Press the ➛
to the right or the left after entering each character. For
example, press the 4 button
press the ❿ button . Press the 7 button
3
to enter the second character, "R". Repeat this step until
all letters have been entered (up to 16).
1
2
1
Using the Key buttons (0-9, *, #)
enter the telephone number, then
press the PROG button
or ❿
button to move the cursor
once to enter a "G", then
5
One second after step 4, "Save ok" will
appear in the display for three seconds
and a confirmation tone will be heard.
21
2
,
again.
three times