Snooze Alarm; Dimmer Control; Sleep To Music Timer - Emerson Research CKS1701 Owner's Manual

Snooze Alarm

After the radio or buzzer alarm sounds in the morning you may press the SNOOZE
(SLEEP OFF) Bar for a few more minutes sleep. The alarm will stop for
approximately 9 minutes and then turn on again. You may repeat the Snooze
operation up to seven times if desired, but after the seventh time the alarm will not
turn on again.

Sleep To Music Timer

You can program the sleep timer to play the radio for up to 90 minutes and then
shut off automatically.
1.) Press the SLEEP button.
The display will briefly show "10" and the
radio will begin to play.
After 10 minutes the radio will shut off automatically. Each time you press the
SLEEP button the sleep timer will start at 10 minutes. This is the sleep timer
default setting.
2.) To increase or decrease the amount of time that the radio will play before
shutting off, hold the SLEEP button and press either the SET + or – button to
change the display to the desired sleep time, up to a maximum of 90 minutes
or a minimum of 2 minutes.
NOTE: When you change the sleep timer from the 10 minute default setting to
a different setting, the new setting becomes the default setting. Whenever you
activate the sleep timer it will begin with your new default setting and count
down to zero from that point.
3.) To cancel the sleep timer before it counts down to "00" and shut the radio ' Off'
immediately, press the SNOOZE (SLEEP OFF) Bar.
IMPORTANT: Remember that the station and volume settings you choose for the
Sleep To Music operation are the same settings you will hear if you set the alarm
for wake to radio the following morning.

Dimmer Control

The DIMMER control was set to the HI (High) position at our factory. If you find the
clock display is too bright in a darkened room, set the Dimmer control to the LO
(Low) position.
CKS1701_032306.p65
14
14 23/3/2006, 14:44