Coby TFTV3229 User Manual page 14

COAXIAL (S/PDIF) - General Information
This port is usually found on digital audio equipment such as a DAT (Digital Audio Tape) machine or audio
processing device. It allows the transfer of audio from one file to another without the conversion to and from
an analog format, which could degrade the signal quality. The most common connector used with an S/PDIF
interface is the RCA connector, the same one used for consumer audio products. An optical connector is also
sometimes used.
COAXIAL(S/PDIF) Connection
Send the TV's audio signal to an external audio equipment via COAXIAL Output port. A 75 ohm coaxial
cable is required for this connection. If you want to enjoy digital broadcasting through 5.1-channel speakers,
connect the COAXIAL terminal on the back of TV to a Home Theater (or amp).
Notice : Coaxial digital audio output only operates under the HDMI and Digital TV mode.
External Audio and Video Signal Input - HDMI, RCA, COMPONENT.
The player's AV function would enable users to view programs from external signal sources.
• Three input modes are available for you to chose from, we have them ranked as below in regard to
image definition: HDMI, COMPONENT, RCA.
After cable connection, set the unit into the relevant input mode with the Source button to enable the
signal pass.
NOTE:
We supply one set of AV cable with this product. The white/red plug of the
RCA cable is for the audio L/R connection and the yellow plug for the video connection.
The white/red plug of the RCA cable can also be used separately to input the audio
signal in the S-video/Component connection.
necessary connections are not included with this product, please check with
your electronic store.
IMPORTANT NOTICE - When work with an external device,
• Be sure to have all necessary connections properly done before connect the
power supply.
• Set the unit into the relative input/output mode to enable the signal pass.
• Refer to the manual of external devices as well.
Cable Connections
The rest of cables required for other
8
NOTE: If you can not hear
anything after COAXIAL(SPDIF)
connection , set the SPDIF as
PCM via "Digital Audio/SPDIF"
option under the "Audio Menu".
See page 12 for details.
CAUTION:
Do not look into the output port.
Looking at the laser beam may
damage your vision.