Table of Contents
Advertisement
CNWR-811P User Guide
•
To Enable a defined Application
- Select it from the drop-down list
- Click "Get Data"
- Check the Enable checkbox
- Click "Update"
•
To Disable a defined Application
- As above, but uncheck the Enable checkbox.
•
To Delete a defined Application
- Select it from the drop-down list,
- Click "Delete"
•
To Modify (Edit) a defined Application
- Select it from the drop-down list,
- Click "Get Data"
- Make any desired changes
- Click "Update"
•
To Create a new Application
- Click "Clear Form"
- Enter the required data, as described below
- Click "Add"
•
To List all Applications
- Click "List All"
Configuration Data (from Service Provider)
This data must be obtained from the service provider.
Name
Enter a descriptive name to identify this application entry.
Enable
Use this to Enable or Disable support for this application, as required.
Outgoing
Protocol
The protocol (TCP or UDP) used when you connect to the special applica-
tion service.
Port Range:
The beginning of the range of port numbers used by the application server,
Start
for data you send to it. If the application uses a single port number, enter it in
both the "Start" and "Finish" fields.
Port Range:
The end of the range of port numbers used by the application server, for data
Finish
you send.
Incoming
Protocol
The protocol (TCP or UDP) used when the application or service sends data
to you.
Port Range:
The start of the range of port numbers used by the application server when
Start
data is sent to you. If using only one port number, enter it in both the "Start"
and "Finish" fields.
Port Range:
The end of the range of port numbers used by the application server, when
Finish
data is sent to you.
46
Advertisement
Table of Contents
