Table of Contents
Advertisement
WAN Status – PPPoE
Status Data
WAN Status
Physical Address
IP Address
Network Mask
PPPoE Link
Status
Connection Log
Log Data
Buttons
Connect
Disconnect
Clear Log
Figure 12: WAN Status – PPPoE
The "Hardware" address of this device, as seen by other devices on the
WAN.
The IP Address of this device, as seen by devices on the WAN.
(This device has 2 IP Addresses; one for the local LAN, and another
for the WAN port.)
The Network Mask (Subnet Mask) for the IP Address above.
This indicates whether or not the connection is currently established.
If the connection does not exist, the Connect button can be used to
establish a connection.
If the connection currently exists, the Disconnect button can be used to
break the connection.
The Connection Log shows status messages relating to the existing
connection.
The most common messages are listed in the following table.
If not connected, establish a connection to your ISP
If connected to your ISP, hang up the connection.
Delete all data currently in the Log. This will make it easier to read new
messages.
Configuration
21
Advertisement
Table of Contents
