Remote Start Faults - Clifford 510.4X Owner's Manual

Remote Start Faults

For user safety, the system must be properly configured or remote
start will not activate. A Remote Start Fault may be caused by any of
several configuration issues. Refer to the table below for the command
type and parking light flashes that will identify the configuration issue
and solution.
Flashes * Possible Fault
5 Brake on
6 Hood open
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
8 Toggle Switch off
None Alarm is triggered
* Refers to the number of parking light flashes.
© 2010 Directed Electronics. All rights reserved.
Solution
Release foot brake
Close hood
Enable MTS mode
Check all Solutions
Turn switch on
Disarm or reset alarm
25