Byron Home Easy HE-303 Installation Instructions

HE-303 Remote
HOME
control Indoor PIR
easy
RE-INVENTING THE HOME
The HE-303 Indoor PIR adds extra security and ease of
use to your Home Easy products
-Selectable timer setting
-Selectable Detection Range
-Veriable Light setting
-25 Metre Wire Free Range
-Battery Powered 2*AAA
The HE-303 allows you to control your
HomeEasy Receiver sockets or modules via a wire free
PIR sensor. When the PIR beam is broken the indoor PIR will switch
on your Remote control sockets or modules for between
5 seconds to 10 minutes, Ideal for controlling house hold lighting.
Compatible with all Home Easy products.
Installation:
The HomeEasy Indoor PIR can be placed in any location, even in bathrooms.
Only use the adhesive strip on suitable surfaces.
Avoid placing the PIR in direct sunshine, above direct heat sources or on
metallic surfaces.
1. Using a small screwdriver remove the front cover and base plate.
V1.0
2. The base unit can be attached to the wall using either the adhesive strips or
screws (Included).
3. Replace the two front covers.
Detection Area
Detection Range:
The Indoor PIR has 3 selectable detection ranges: 1, 3 or 6 Metres.
To alter the detection range, remove the front cover and move the slide switch
to the required setting.
6M 6M 6M
3M 3M 3M
1M 1M 1M
1.0
1 2 3 4 5 6 7 8
Detection Distance (Metres)
Detection Angle:
The PIR detection area is 65 degrees, this can be reduced using the clip-on
covers (included). if required the covers can be cut to size.
Pairing/Deleting with Remote Control:
Up to Six remote control units can be paired with each
HomeEasy Receiver socket or module, to pair the indoor
PIR with a receiver unit, remove the front cover and,
slide the switch to DEL.
Now press the "Learn" button, the LED will start to flash, then slide the
"LEARN" switch to "SET", the units are now paired together.
Example
6M 6M 6M
1.5 3M 3M 3M
1M 1M 1M
Deleting Remote Control:
To delete the PIR from the memory of a HomeEasy receiver socket or module
1 2 3 4 5 6 7 8
control , simply press the "Learn" button. The LED will start to blink; slide the
"LEARN" switch to "DEL",, the LED will blink twice to confirm that the remote
control has been removed from the receiver sockets memory.