Advertisement
STEP 5
Enabling VoIP
To enable VoIP, copy and paste the following output once you are in config-t mode: R1(config-t)#. These
are the changes that need to be made:
YourGwName
12345678900x
X.X.X.X
** If your Cisco 827-4v has a public ip address then use:
session target ipv4:
** If your Cisco 827-4v is behind NAT (has private IP address) then use:
session target ipv4:
Here is the list of the private IP addresses on the Internet:
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Go through and make the necessary changes, as indicated in red:
voice-port 1
connection plar 723
station-id number
!
voice-port 2
connection plar 723
station-id number
!
voice-port 3
connection plar 723
station-id number
!
voice-port 4
connection plar 723
station-id number
!
Copyright © 1999-2005 Go2Call.com, Inc. and/or its suppliers. All rights reserved. "Go2Call" and all associated logos are trademarks, registered as applicable, of Go2Call.com, Inc., and may not be reproduced without Go2Call's permission. Other product
and company names herein may be the trademarks of their owners. This document is provided "as-is" by Go2Call.com, Inc. for the user's internal and non-commercial use. Go2Call.com, Inc. does not promise that the information herein is accurate or
complete and all use of such information is solely at the user's risk. All warranties disclaimed.
ßReplace with your Gateway name or Company name.
ßReplace with your PIN number.
ßReplace with your IP address from the Ethernet port.
216.52.153.209
216.52.153.217
123456789001
123456789002
123456789003
123456789004
Cisco 827-4V Gateway Configuration
With Go2Call Prepaid Voice Service
Change with your PIN
Change with your PIN
Change with your PIN
Change with your PIN
page 3 of 4
Advertisement
