Connecting The Monitor And Turning The Monitor On And Off; Connecting The Monitor To A Computer - Sharp LL-T15G4-H - 15" LCD Monitor Operation Manual

Connecting the monitor and turning the monitor on and off

CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.
Storing the cables
If necessary, cables can be stored inside of the
stand.
1. Remove the cover.
Pull the cover open while pushing the right and
left tabs of the cover.
2. Run cable along the back of the stand. Refit the
cover.
Be careful not to pinch the cable.
CAUTION!
- When adjusting the viewing angle, cables and
cords may be pulled. Therefore, ensure that the
cables and cords have sufficient slack.
cover
11

Connecting the monitor to a computer

Analog connection
- Use the accessory analog signal cable.
Analog signal cable
- Paying attention to connector direction, firmly
insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.
If connecting to a D-sub15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.
Macintosh conversion adapter
Analog RGB terminal
(Mini D-Sub15 pin, 3 row)