Rs-232C Connector; Dc Out (Trigger Out) Jacks - Marantz AV7005 User Manual

ENGLISH DEUTSCH

RS-232C connector

When you connect an external control device, you can control this unit
with the external control device.
External serial controller
Perform the operation below beforehand.
q Turn on the power of this unit.
w Turn off the power of this unit from the external controller.
e Check that the unit is in the standby mode.
54
FRANÇAIS ITALIANO ESPAÑOL

DC OUT (TRIGGER OUT) jacks

When a device with DC IN jack is connected, the connected device's
power on/standby can be controlled through linked operation to this
unit.
The DC OUT jack outputs a maximum 12 V/150 mA electrical signal.
12 V/150 mA trigger-compatible device
in Set as Necessary
Set to change the conditions for linked operation via the DC OUT
1 or 2 jack.
"Trigger Out 1" or "Trigger Out 2" (vpage 85)
NOTE
If the permissible trigger input level for the connected device is larger
than 12V/150 mA, or has shorted, the DC OUT jack cannot be used.
In this case, turn off the power to the unit, and disconnect it.
NEDERLANDS SVENSKA