Error Messages - Marantz AV7005 User Manual

Set up speakers (Audyssey ® Auto Setup)
Finish
15
Unplug the setup microphone from
the unit's SETUP MIC jack.
16 Set Dynamic Volume ® .
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ XT
Finish [6/6]
Storing complete.
Auto Setup is now
finished. Please unplug
microphone.
Turn on Dynamic Volume?
Yes No
ENTER Exit
Turn Dynamic Volume on and exit Auto Setup
• For details of Dynamic Volume settings, see
page 75.
n When turning Dynamic Volume on
ENTER
Use o to select "Yes", and then press
• The unit automatically enters "Heavy" mode.
n When turning Dynamic Volume off
ENTER
Use p to select "No", and then press
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Remote control operation
buttons
SVENSKA NEDERLANDS

Error messages

An error message is displayed if Audyssey ® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens,
check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Examples
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
No microphone or Speaker
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ XT
Caution!
Ambient noise is too high
or Level is too low
.
Retry
RETURN Cancel
Check cause of problem!
.
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
Front R None
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
Front L Phase
Retry
Skip
RETURN Cancel
Check cause of problem!
Move the cursor
(Up/Down/Left/Right)
ESPAÑOL ITALIANO
Error details
• The connected setup microphone is broken, or a
device other than the supplied setup microphone is
connected.
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• There is too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for accurate
measurements to be made.
• The displayed speaker could not be detected.
• The displayed is connected with the polarities
reversed.
Confi rm the setting
FRANÇAIS DEUTSCH
Measures
• Connect the included setup microphone to the
SETUP MIC jack of this unit.
• Check the speaker connections.
• Either turn off any device generating noise or move
it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, press
ENTER
to select "Skip", then press .
Return to previous menu
ENGLISH
ui
11