9.2.6. Removing the LCD Knob and the
Speaker
Preparation : perform the section 9.2.1., 9.2.2.
and 9.2.4. first.
1. Remove the latch spring from the top case.
2. Remove the hook of the LCD knob from stopper rib
of the top case.
3. Peel off the4.Peel off the tape on the speaker and
speaker ring and then remove the speaker.
9.2.7. Removing the USB Board
Preparation : perform the section 9.2.1., 9.2.2.
and 9.2.4. first.
1. Peel off the tapes and RJ cable sheet for clamp the
USB cable.
Tape : TPD-X0033A (S1001)
RJ Cable Sheet : DFHR3C13ZA (K53)
2. Remove the connector (CN23) on the main board.
3. Remove the USB board from the bottom case.
9.2.8. Removing the Main Board
Preparation : perform the section 9.2.1., 9.2.2.
and 9.2.4. first.
1. Remove the 1 screw (I ), 1 screw (J), 2 screws (K)
and 2 screws (L ).
Screw (I ) : DXQT2+E10FNL (N10)
Screw (J) : DXQT2+D4FNL (N9)
Screw (K) : DFHE5035ZB (N2)
Screw (L) : K1YE50000022 (N1003)
2. Remove the 2 screws (M).
Screw (M) : DXQT2+E6FNL (N12)
3. Remove the modem cable from the MDC modem.
4. Remove the side cover (L) from the bottom case.
5. Remove the DC jack holder on the DC-IN jack.
26