Housing Removal - Epson Stylus PHoto 875DC Service Manual

EPSON Stylus PHOTO 875DC

4.2.1 HOUSING Removal

Since the printer mechanism itself structures the bottom part, it appears
just by removing HOUSING.
1. Set the PG adjust lever to "+".
2. Using the tweezers, release the hook securing HOUSING, SUPPORT,
PG COVER to HOUSING and remove HOUSING, SUPPORT, PG
COVER from HOUSING.
HOUSING, SUPPORT,
PG COVER
Figure 4-2. HOUSING, SUPPORT, PG COVER Removal
3. Remove the four screws (CBS, 3x10) securing HOUSING. Then,
pushing the PG lever inward, remove HOUSING by moving it upward.
!
To remove HOUSING, push it to the rear up and then lift it
up.
!
When installing HOSING, make sure the PG adjust lever is
set to "+".
!
When installing HOUSING, ensure the head FFCs are not
caught in HOUSING at the back of the printer.
DISASSEMBLY AND ASSEMBLY
dis03
Disassembly Procedures
CBS (3x10) Screws
CBS (3x10) Screws
Figure 4-3. HOUSING Removal
Revision A
HOUSING
dis04
33