Upper Exit Chute Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.51 Upper Exit Chute Assembly

Refer to the exploded diagram (Figure 4-36, "Exit" on page 183).

3.4.51.1 Removal

1. Remove the Eject Pinch Roll Shaft Assembly. (Refer to "Eject Pinch Roll
Shaft Assembly" on page 100)
2. Remove the screw securing the Finisher Stapler Interlock Switch Bracket
to the front of the HCS frame and remove the Bracket to enable to remove
the screw of the Upper Exit Chute Assembly.
3. Remove two screws securing the Upper Exit Chute Assembly to the front
of the HCS frame.
4. Remove two screws securing the Upper Exit Chute Assembly to the back
of the HCS frame.
5. Remove the Upper Exit Chute Assembly from the HCS by revolving it.

3.4.51.2 Installation

1. Install the Upper Exit Chute Assembly to the HCS frame.
2. Place four threaded holes of the Upper Exit Chute Assembly to those of
the HCS frame.
3. Secure the front side of the Upper Exit Chute Assembly to the HCS frame
with two screws.
4. Secure the rear side of the Upper Exit Chute Assembly to the HCS frame
with two screws.
5. Install the Finisher Stapler Interlock Switch Bracket to the front of the HCS
frame and secure the Bracket with a screw.
6. Install the Eject Pinch Roll Shaft Assembly. (Refer to "Eject Pinch Roll
Shaft Assembly" on page 100)
Disassembly and Assembly Disassembly and Assembly
Figure 3-59. Upper Exit Chute Assembly
Revision A
95