EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler
3.4.10 Finisher Stapler PWB Cover and Connector
Cover
Refer to the exploded diagram (Figure 4-26, "HCS Covers Rear" on page 167).
3.4.10.1 Removal
1. Remove the screw securing the Connector Cover and remove it.
Connector Cover
Figure 3-14. Connector Cover
2. Remove Harness Cover. (Refer to "Harness Cover" on page 46)
3. Remove four screws securing PWB Cover Assembly to HCS frame and
pull out the PWB Cover from the frame.
4. Remove the wire harness from the Top Harness Clamp. (see Figure 3-15)
Disassembly and Assembly
5. Remove the wire harness from the Bottom Harness Clamp.
6. Remove Finisher Stapler PWB Cover.
Bottom Harness Clamp
Harness Cover
Assembly
PWB Cover
3.4.10.2 Installation
1. Install Finisher Stapler PWB to HCS frame. (see Figure 3-15)
2. Let HCS Interface cable through the upper cutout of the Cover.
3. Let AC Power cable through the lower cutout of the Cover.
Disassembly and Assembly
Top Harness Clamp
HCS Interface
Cable
AC Power
Cable
Figure 3-15. Finisher Stapler PWB Cover
Revision A
48