Table of Contents
Advertisement
Always turn the power OFF (with the switch on the right side of the
printer) before you change the setting of any of these switches. Any
changes made while the power is on will be ignored until you turn the
printer off and back on. So set all switches with the power off.
In Table C-l we show you the functions of all the switches. Then we
explain each of them.
No. ON
1-1
Compressed
1-2
NLQ
1-3 Active
1-4
12 inches
1-5
Inactive
Emphasized
1-6
1-7
Double-strike
5
1-8
No. ON
2-1
0 (slashed)
2-2
2-3
2-4 Mute
Note:
The factory setting of all these switches is OFF:
Switch 1-1 selects standard or compressed printing. ON is com-
pressed; OFF is standard. Even if the switch is off, you can use
SelecType to choose compressed.
Switch 1-2 selects draft or Near Letter Quality printing. When it is
ON, the printer prints in the NLQ mode. When it is OFF, it prints in
the draft mode. If the switch is off, you can still choose the NLQ mode
with SelecType.
Switch 1-3 controls the optional cut-sheet feeder. Leave it off unless
you are using a cut-sheet feeder.
Switch 1-4 selects the page length. When it is OFF, the length is 11";
when it is ON, the length is 12".
C-2
Table C-1. DIP switch functions
Switch 1
Function
Print mode
Print mode
Cut-sheet feeder
Page length
Paper end detector
Print mode
Print mode
Device number
Switch 2
Function
Zero character
Not used
Not used
Beeper
OFF
Standard
Draft
Inactive
11 inches
Active
Standard
Standard
4
OFF
0
Active
Advertisement
Table of Contents
