Attaching The Machine Parts Removed For Shipping - Duerkopp Adler 744-122 Installation Instructions Manual

5. Attaching the Machine Parts removed for Shipping

For reasons of transport the sewing unit was
dis-assembled to about half of its total length. The
parts are to be re-attached in the following order:
5.1 Left guide for the transport carriage
– Screw the red-marked right mounting rod 9 into
the red-marked hole 10 on the machine arm.
Screw the left mounting rod 7 into the hole 8 on
the machine arm.
Prior to this the mounting for the protective
plate must be affixed.
Attention! The position of the yellow sealed lock
nuts 11 at the end of the rods must not be
changed.
– Screw the black rods 5 into the pipe brackets
17.
– Push the guide pipes 18, held clamped in the
cast part 12, onto the black rods. Then plug the
guide pipes onto the pipe brackets 17.
– Plug the plate 14 on to the ends of the black
rods 5. At the same time place the spacer
washers 13 between the cast part 12 and the
plate.
Tighten all parts with the black nuts 15 so that
the guide pipes lie tightly on the pipe brackets.
– Tighten the support rods with the nuts 16.
17
18
4
5 1 17 1
16
15
6 1 7
8 9
11 12
10
13
14