Epson Stylus 820 Service Manual page 123

Adjustments
4.1.1 Destination Data Writing Operation
The setup value that specifies the printer destination (for character generation and panel default
settings) is stored in the EEPROM on the C160 MAIN Board. Therefore, this setup value must be
written into the EEPROM when the main board or EEPROM chip is replaced.
1.
2. Execute BASIC on the PC, and run the program HUDSON.BAS. You see the following menu:
Stylus / MJ Program H90EOOE
***** Model *****
1. Stylus Color 11s
2. Stylus 820
3. MJ-500C
7. END
3. When the main menu appears, choose the product name by typing 1 or
4. You see the following menu.
Stylus / MJ Program H90EOOE
***** Customer *****
1. EAI, EAI (Latin America), EAL, ESP, EIT
2. EUL, EDG, EFS, EIS, EIB, EUL (North Europe), EUL (Middle East), EHK
3. [EDG (NLSP)]
4. Russia
Sleet Menu ?
5. Select your country.
6. If you have completed all your selections, turn off the printer.
Note: It is not necessa~ to turn off the printer if you want to perform the other adjustments.
4-2
Stylus Color 11s /Stylus 820
and Enter.
2
Rev. A