Appletalk Settings - HP Jetdirect 250M User Manual

(Read-only parameter) Identifies the IPX network and node
numbers detected on the network, in the form
Address NNNNNNN:hhhhhhhh (hexadecimal), where NNNNNNNN is the
network number and hhhhhhhh is the LAN hardware address of the
print server.
Specifies the IPX frame type setting: AUTO (default), EN_SNAP,
ipx-
EN_8022, EN_8023, EN_II, TR_8022, TR_SNAP. For more
frametype
information, see
Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect
ipx- print server waits between Service Advertising Protocol (SAP)
sapinterval broadcasts on the network. The default is 60 seconds. 0 disables SAP
broadcasts.
ipx-nds- An alphanumeric string, up to 31 characters, that specifies the NDS
tree tree name for the print server.
ipx-nds- An alphanumeric string, up to 256 characters, that specifies the NDS
context context for the HP Jetdirect print server.
Specifies the time interval (1 to 255 seconds) that the HP Jetdirect
ipx-job-poll print server will wait to check for print jobs in a print queue. The
default is 2 seconds.
Enables or disables printing an IPX banner page via Printer Job
ipx-banner Language (PJL). 0 disables banner pages. 1 (default) enables banner
pages.
Enables or disables IPX end-of-job notification via PJL. 0 disables, 1
ipx-eoj
(default) enables.
ipx-toner- Enables or disables IPX toner-low notification via PJL. 0 disables, 1
low (default) enables.
(Token Ring only) Configures the HP Jetdirect print server with the
IPX/SPX source routing used on the network.
auto (default): Source routing is automatically sensed from the
network.
source- off: Packets are transmitted without source routing. The print server
route will only respond to stations on the same ring.
single r: All packets are sent with source routing. The Single Route
method is used for broadcasts and when the route is unknown.
all rt: All packets are sent with source routing. The All Routes
method is used for broadcasts and when the route is unknown.

AppleTalk Settings

Enables or disables AppleTalk (EtherTalk) protocol operation on the
at-config print server. 0 disables, 1 (default) enables. For example, "at-config
0" will disable AppleTalk operation
(Read-only parameter) The name of the printer on the AppleTalk
Device
network. A number after the name indicates that there are multiple
Name
devices with this name, and this is the Nth instance of the name.
(Read-only parameter) Specifies the AppleTalk network printer type
Print Type
reported by the Jetdirect print server.
HP Jetdirect Configuration Page.