Char-Broil Patio Bistro 10601514 Assembly Manual page 8

8
ASSEMBLY GUIDE
C4 – Controller
C5 – Lid Handle
NOTE: Be sure to press the controller into the receptacle as far as it will go. Route the
controller cord BEHIND the towel bar as shown.
Step 1
- Install the Controller (C4) into the receptacle. Be sure to route the controller cord behind the towel bar when
installing the controller. The control knob should be facing up as you engage the tip of the controller into the receptacle.
Towel Bar
C4
Step 2
- Install the Lid Handle with 2 10-24x3/8" screws and 2 fiber washers as shown.
10-24x3/8"
Fiber
Washer
(2 each)
Congratulations! You have successfully completed the
assembly of your grill.
Visit
Part
C5
Screws
(2 each)
www.sizzleonthegrill.com/user-forums to chat with Patio Bistro® owners just like you!
GRILL FINAL Assembly
Qty.
Fasteners
1
1
Ground Fault Interrupter
Since 1971 the National Electric Code (NEC) has
required Ground Fault Interrupter devices on all
outdoor circuits.
If your residence was built before 1971, check with a
qualified electrician to determine if a Ground Fault
Interrupter protector exists.
Do not use this appliance if the circuit does not
have GFI protection.
Do not plug this appliance into an indoor circuit.
Fiber Washer
10-24x3/8"
screw
(qty 2)
(qty 2)
Receptacle
Controller
Controller Tip