Table of Contents
Advertisement
PROGRAMMING
NOTICE: If this Security ✚
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-
held remote* that you wish to
operate your garage door.
3. Release the button when the
motor unit lights blink. It
has learned the code. If light
bulbs are not installed, two
clicks will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, fi rst erase all
codes:
Press and hold the "learn"
button on motor unit until the
learn indicator light goes out
(approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
garage door opener is operated with a non-rolling code transmitter, the technical measure
®
To Add or Reprogram a Hand-held Remote Control
USING THE MULTI-FUNCTION DOOR CONTROL
9
1
9
1
7
3
7
3
5
5
KG
KG
1. Press and hold the button
on the hand-held remote*
that you wish to operate your
garage door.
2. While holding the remote
button, press and hold the
LIGHT button on the
Multi-Function Door Control.
3. Continue holding both buttons
while you press the push bar
on the Multi-Function Door
Control (all three buttons are
held).
4. Release buttons when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the
large button is factory
programmed to operate it.
Additional buttons on any
Security✚
3-Button remote
®
or mini-remote can be
programmed to operate
other Security✚
35
®
remote controls.
garage door openers.
®
Advertisement
Table of Contents
