2.6
Thread-trimmer cam
10
2
1
Caution – Risk of injury !
Turn the main switch off.
Check and adjust the thread trimmer cam only when the automatic
bartacker is switched off.
Rule and control
The correct position of the thread trimmer cam 1 is marked by a point
on the upper shaft 2 and a line on the thread trimmer cam 1.
The position is correct when both markings are opposite each other.
–
Engage handwheel and turn until the marking points 4 and 5 on the
upper shaft and the thread trimmer cam are visible.
–
Check that both markings are exactly opposite each other.
Adjusting
–
Loosen screws 3 at the thread trimmer cam.
–
Twist and axially shift the thread trimmer cam so that both
markings 4 and 5 are exactly opposite each other.
–
Tighten screws 3.
4
2
3
5
1
1